Free Stuff!

The bins that fill everything else. Set a footprint in 42 mm cells and a height in 7 mm units, then download it — free, as many as you like, whenever a drawer needs one more.

They sit on the standard grid, so they suit our drawer systems, our stands, and any Gridfinity you already print. Ask for one bigger than the build plate for your printer and it's created in snap-together sections instead of refusing.

Raise the screen to where your neck stops complaining. You pick the footprint, the recline, and the bar stock every member is generated from, so the proportions answer to your desk rather than to an average one.

It breaks into four parts that snap together and lie flat on the plate. Printed support-free, which means no scarring across the faces you actually look at and nothing to clean up before it goes together.

Cardboard sags, cracks, and sheds dust into your feed path; refills and sample coils arrive with no spool at all. Print a rigid one instead — wind onto the hub, screw the two halves shut over the coil, and it drops onto any holder you own.

A single 55 mm bore serves all three sizes, so a 250 g sample and a 2 kg reel run on the same rod. Both halves print flange-down, unsupported. Free.

Measure what you want to keep, not the box. Give it an inside length, width and depth and every part rebuilds around those numbers — the hinge grows with the case, so a floss-pick tin and a caliper case are the same design at two sizes rather than two designs.

The hinge prints closed, in place, already hinged. No pin to push, no knuckles to thread, nothing to glue. It lifts off the plate working, and clips into the base and lid on barbed connectors.

Decide how the depth splits: an even clamshell that opens like a book, or a shallow lid on a deep tray when the contents only want one side. A sprung catch holds it shut, and a thumb relief in the rim flicks it open.

Most vertical stands come in small, medium and large, which means yours either rattles in the slot or has to be forced into it. This one is cut for the machine it holds: type in the three measurements and every dimension of the stand is derived from them.

Three clip together parts, no screws, no glue.

Free. Configure it, turn it round in 3D, and download it.

Add an embossed or 3-color logo and help us get the word out!