← All products
Jigs and helpers for jobs around the house, sized to the hardware you are putting in.
Put every cabinet pull and knob in the same spot on every door, drilled straight.
Hook the lip over the edge of the door, line the center notch up with your pencil mark, clamp it and drill. The holes land the right distance from the edge and the right distance apart on every door, so a whole kitchen of pulls lines up.
The guide holes are half an inch long, so the bit cannot wander or tilt, and a groove where the lip meets the face lets the guide seat tight against an eased edge. Each guide is labeled with its spacing and distance in inches and millimeters.
Drill drawer pulls and knobs straight and at the same height on every drawer.
Hook the lip over the top of the drawer front, line the center notch up with your pencil mark, clamp it and drill. The holes land at the same height and the same distance apart on every drawer, so a run of drawers lines up from one end to the other.
We size every model to your printer, so we need to know how big it can print. It’ll be saved for the next person with the same machine.
These are the printable sizes — the biggest part your printer can actually make, the numbers your slicer shows as the build volume. Not the bed or the removable plate, which are usually a little bigger.
The build plate is the removable sheet you pop prints off; it’s usually a little bigger than the printable area. A plate rack is cut to the sheet, not the bed.
A printer stand is built around your printer’s feet. Give us all four and we can build you one — or skip them and add them later. Measure the BASE — the slab it stands on — not the machine’s widest point. Gantry legs, Z columns and X arms usually overhang the base and hold up nothing.
Every model is sized to the printer doing the printing, and the logo and engraved sizes come as color inlays only where you can print them. The one at the top is the one new configurations start on — pick any row to make it that.
Adding one is the same picker: choose it in My Printer, or add one we don’t list yet.
Every model on the site opens in these three. Primary is the largest surface, secondary the part that contrasts with it, and tertiary the accent — feet, trim, the parts that tie it together.